Version June 2024
| Digihaler |
| Hold the inhaler in an upright position and open the cap. A "click" sound means that the next dose is ready. |
| Breathe out fully - do not exhale into the device. |
| Place the mouthpiece into your mouth and close your lips tightly around it. |
| Breathe in rapidly and steadily, as deeply as possible; remove the inhaler from your mouth and hold your breath for 10 seconds. |
| Close the cap after each dose. |
| Store device in a cool, dry place. |
| The dose counter displays the number of doses remaining. |
| Diskhaler |
| Remove mouthpiece cover and pull tray out from device. |
| Place disk on wheel with numbers facing up. |
| Rotate disk by sliding tray out and in. |
| Lift back of lid until fully upright so that needle pierces both sides of blister. |
| Keep device level while inhaling dose with a rapid and steady flow. |
| Breathe in rapidly and steadily, as deeply as possible; hold your breath for 5 to 10 seconds. |
| Remove device from mouth and exhale outside device. |
| Brush off any powder remaining within device once every week; store device in cool, dry place. |
| Diskus |
| Open the device and slide the lever until it clicks. |
| Keep device level while inhaling dose. |
| Breathe in rapidly and steadily, as deeply as possible; hold your breath for 5 to 10 seconds. |
| Remove device from mouth and exhale outside device; store device in cool, dry place. |
| Flexhaler |
| Prime the inhaler: This is done only with the initial dose. Holding the inhaler in the upright position, twist the brown grip as far as it will go in one direction, then twist it all the way back in the other direction. A click will be heard during one of the turns. This step should be repeated to complete the priming of the device. |
| Load a dose: Holding the inhaler in an upright position, twist the brown grip as far as it will go in one direction, then twist it all the way back in the other direction. |
| Inhale the dose: Turn away from the inhaler and breathe out. Then place the mouthpiece in your mouth, close your lips, and inhale deeply. |
| Twisthaler |
| Hold the inhaler straight up with the pink portion (the base) on the bottom. |
| Remove the cap while it is in the upright position to make sure you get the right amount of medicine with each dose. |
| Hold the pink base and twist the cap in a counter-clockwise direction to remove it. |
| As you lift off the cap, the dose counter on the base will count down by one. This action loads the medicine that you are now ready to inhale. |
| Make sure the indented arrow located on the white portion (directly above the pink base) is pointing to the dose counter. |
| Breathe out normally - do not exhale into the device. |
| Place the mouthpiece into your mouth, with the mouthpiece facing towards you, and close your lips tightly around it. |
| Inhale dose with a rapid and steady flow while holding the Twisthaler horizontal. |
| Remove the mouthpiece from your mouth and hold your breath for 5 to 10 seconds (or as long as you comfortably can). |
| When you exhale, be sure that you are not exhaling into the device. |
| Immediately replace the cap and turn in a clockwise direction as you gently press down until you hear a click. |
| Firmly close the Twisthaler to assure that your next dose is properly loaded. |
| Be sure that the arrow is in line with the dose-counter window. |
| Store device in a cool, dry place. |
| The dose counter displays the number of doses remaining. When the unit reads 01, this indicates the last remaining dose. When the counter reads 00, the unit must then be discarded. |
آیا می خواهید مدیلیب را به صفحه اصلی خود اضافه کنید؟
